Pool Leak Detection — Juno Beach, FL

Coastal Evaporation vs. Real Leak Behavior

Juno Beach pools can see noticeable evaporation from wind, sun, heater use, and open coastal exposure. That does
not mean every low waterline is a leak. The difference is whether the pool loses more than a bucket of water
sitting in the same conditions.

A bucket test gives you a cleaner answer. If the pool and bucket drop about the same amount, evaporation is more
likely. If the pool drops more than the bucket, the pool is losing water beyond normal weather-related loss.

Condos, Townhomes, and Tight Equipment Areas

Juno Beach has a mix of single-family pools, condo pools, townhome communities, and coastal properties where
equipment access may be tighter than a typical backyard pool. That matters because some leaks are easy to see
at the pad, while others require a more careful look around walls, drains, shared equipment spaces, or deck edges.

If you are in a condo or managed community, save the water-loss numbers and photos before calling. That makes it
easier to explain the issue clearly to a manager, HOA, maintenance contact, or leak specialist.

• Note whether the pool is private, shared, condo, or HOA-maintained.
• Take photos of the waterline mark and equipment area.
• Write down whether autofill was on or off during testing.
• Check whether water appears near deck drains, walls, or equipment pads.

Water Loss That Changes When the Pump Runs

If the pool loses more water while the pump is running, the problem may be connected to return plumbing,
pressure-side fittings, a heater, filter connections, cleaner lines, spa spillover plumbing, or a water feature.

If the water keeps dropping even when the pump is off, look more closely at static leak points such as the shell,
skimmer throat, light niche, return fittings, tile line, steps, or visible cracks.

• Compare a pump-running window with a pump-off window if safe.
• Look at the equipment pad while the system is under pressure.
• Note whether a heater, spa spillover, waterfall, or cleaner line was running.
• Save the drop-rate numbers instead of relying on memory.

Related: Pool leaks when pump is running

Light, Skimmer, Return, or Tile-Line Clues

In coastal areas, fittings and seals can become important clues. Skimmer throats, return fittings, light niches,
tile lines, grout, and shell cracks are all worth watching if the water drops to a repeat level.

A light conduit issue can be especially frustrating because the pool may lose water near the light height, or
symptoms may appear around electrical/GFCI behavior. Do not guess at electrical-related problems. Save the water
level clue and get it checked safely.

• Skimmer-level stop may point toward the skimmer throat or faceplate area.
• Light-level stop may point toward the light niche or conduit.
• Return-level stop may point toward a fitting or nearby line.
• Tile-line stop may point toward grout, shell movement, or waterline cracks.

Wet Equipment Pad, Soft Ground, or Damp Deck Edge

A wet equipment pad or damp deck edge can be one of the easiest clues to dismiss. Small drips around unions,
valves, filters, pump lids, heaters, chlorinators, or return-side fittings can add up over a full pump cycle.

Water can also travel under decking before it shows up. That means the wet area may not sit directly above the
leak, but the timing still matters. If the area gets wetter while the pump runs, that detail is important.